48 / 69
ON/OFF
CHECK CHARACTERS
MSI barcodes use different types of checksum characters. You can configure the device to read MSI
barcodes using checksum characters. Default = enable MOD10, but no transmission.
When "Check Character" is set to "Enable MOD10 and Transmit", the device will only read and use
MSI barcodes printed with the specified type of check characters, and will transmit characters at the
end of the scanned data.
When "Check Character" is set to "Enable MOD10, No Transmission", the device will only read and
use the MSI barcode printed with the specified type of check character, but will not transmit the
scanned check character.
CODE READING LENGTH
Scan the following barcode to change the reading length. For additional information, please refer
to the code length description. The minimum and maximum length is 4-48. Minimum default value
=4, and maximum default value =48. (Note: After scanning "Minimum Barcode Length" and
On
*Off
* MOD10 Enabled, No
Transmission
MOD10 Enabled and
Transmit
Disable MSI Check
Characters
