Waves HPSA-7100-R Series, Installation And User Manual

Page: 86 / 179

Activating the HPSA-7100-R
60 HPSA-7100-R Series Installation and User Manual
P/N P01- 04946 Rev C
3. Open the electronics compartment as described in Section 6.1.
4.
Disconnect the NAC In or CC In (depending on the configuration for activating
the HPSA) connection on the Audio and Monitoring Bridge; this will prevent the
speakers from activating while adjusting the audio input level.
5. Disconnect the Channel Output connections from the Amp Board to each
HPSA driver.
6. Apply power to the HPSA by pushing the red power button adjacent to the PDB.
The following responses occur when the power is applied:

The Control Panel LCD displays a bootup screen followed by the Main Menu.

The appropriate LEDs on the PDB board illuminate.

All Trouble LEDs on the AMB should be OFF

A short beep is heard from the Control Panel.

A Silent Test occurs. A Silent Test occurs every three minutes automatically.
FIGURE 7.1 Red Power Button
Push the red
Power Button,
adjacent to the
PDB