Waves HPSA-7100-R Series, Installation And User Manual

Page: 55 / 179

HPSA-7100-R Series Installation and User Manual 29
P/N P01- 04946 Rev C
Installing a Wall Mount
4.3.0.2 Ground Mounting the Electronics Cabinet
1. Position the electronics cabinet in the location determined in the site design.
2. Mark and drill the mounting holes for each pedestal (three per pedestal).
3. Using appropriate mounting hardware (not provided), place in the mounting hole
locations.
4. Position the electronics cabinet on the mounting hardware and secure.
5. Replace and secure the battery shelf.
FIGURE 4.2 HPSA Pedestal Dimensions
4.4 INSTALLING A WALL MOUNT
The HPSA-7100-R Electronics Cabinet can be wall mounted, as shown in Figure 4.3, per
the site design.
1. Gather the cabinet and Hardware Kit and mounting hardware.
2. Measure the four mounting positions on the back of the electronics cabinet.
3. In the location determined in the site design, mark the positions for the mounting
positions.
Refer to the structural, mechanical, or civil engineer to ensure compliance
with local codes and requirements.
Refer to the structural, mechanical, or civil engineer to ensure compliance
with local codes and requirements.