WaveRider NCL1170, User Manual

Page: 27 / 97

3 Installing the NCL1170
APCD–NC006–A 13
Figure 9 Console Port Pin-out Diagram
3. If you are using a terminal-emulation package, such as HyperTerminal, start the
application.
4. In the terminal-emulation application, select the communications port that you are
using to connect to the NCL1170.
5. Configure the application using the following settings:
• 9600 bps
• 8 data bits
• no parity
• 1 stop bit
• no flow control
6. Plug the NCL1170 into a 110 or 220 V AC power source using the custom power cord
provided with the unit.
NOTE: When disengaging and removing the NCL1170 power cord,
carefully slide back the locking collar around its DC connector.
DB9 Male DTE Configuration
Pin 2 Tx line
Pin 3 Rx line
Pin 4 DSR
Pin 5 Ground
Pin 6 DTR
9 8 6 7
5 4 3 2 1