APCD-WM001-1.0
29
Appendix B Ethernet Cables and
Connectors
The MMT9000 may use cross-over or straight through Ethernet cables, depending on the type
of installation:
•
Cross-over Cable
: If a cable is connected directly between the MMT9000 and a PC,
use a crossover Ethernet cable. A cross-over cable has one end wired according to
T568A and the other end according to T568B. Both ends have RJ45 connectors.
•
Straight-Through Cable
: If MMT9000 is connected to an Ethernet switch or router
use a straight-through Ethernet cable, which has both ends wired according to T568A
(or both according to T568B) with RJ45 connectors.
The Ethernet cable used for the MMT9000 must have at least the RX and TX pairs wired as
shown in
with NO power on the other wires.
