WaveRider LMS4000, User Manual

Page: 97 / 282

6 Installation/Diagnostic Tools
APCD-LM043-4.0 79
Hash mark printing On ftp: (2048 bytes/hash mark) .
ftp> binary
200 Type set to I, binary mode
ftp> get sa1110.bak
200 Port set okay
150 Opening BINARY mode data connection
############################################################################
###
############################################################################
###
##################################################################
226 Transfer complete
ftp: 463713 bytes received in 10.80Seconds 42.96Kbytes/sec.
ftp>bye
221 Bye...See you later.
4. Enter the following commands to put the sa1110.bak file to the CCU.
Connected to <aaa.bbb.ccc.ddd>.
220 FTP server ready
User (<aaa.bbb.ccc.ddd>:(none)):
331 Password required
Password:
230 User logged in
ftp> hash
Hash mark printing On ftp: (2048 bytes/hash mark) .
ftp> binary
200 Type set to I, binary mode
ftp> put sa1110.bak null
200 Port set okay
150 Opening BINARY mode data connection
############################################################################
####
############################################################################
####
##################################################################
226 Transfer complete
ftp: 463713 bytes sent in 8.30Seconds 55.86Kbytes/sec.
ftp>bye
221 Bye...See you later.
Entering
null
after the put command ensures the file will not be permanently stored to CCU
memory. If you inadvertently forget to enter
null
after the put command and save the file to
CCU memory, the throughput performance of the CCU may be reduced significantly. You can
remove the file using the CCU file services, available through the command line interface. As
long as you enter
null
after the put command, any size file can be used.
The FTP throughput should correspond to a value slightly less than the maximum allowed by
the GOS, assuming no other traffic is being carried by the CCU.
6.6 Operating Statistics
The CCU and EUM collect a wide range of IP, radio, MAC, and network layer statistics, which
can be used for measuring system performance and troubleshooting. These statistics can be
accessed through the command line interface, outlined in
Appendix C on page 163 or by using
an SNMP manager. A list of available statistics and their meanings can be found in Appendix
H on page 223 .