WaveRider EUM3006, Installation Manual

Page: 16 / 64

:
APCD-LM048-1.1 xvi
be slow even under normal operations due to network congestion and radio
interference and fading and not as result of problems with the EUM3006.
• When the EUM3006 or PoE Injector exhibit distinct changes in performance. This
may indicate a need for service.
21. When replacement parts are required, be sure the service technician has used
replacement parts specified by the WaveRider or with the same characteristics as the
original part. Improper substitutions may result in fire, electric shock or other hazards.
22. Upon completion of any service or repairs to this wireless product, ask the service
technician to perform safety checks to determine that the wireless product is in proper
operating condition.
23. Follow WaveRider recommendations when mounting the EUM3006 on a wall, roof, or
tower.
24. Install the EUM3006 in compliance with local and national electrical codes. The
following are the national codes. The installer is responsible for knowing the
appropriate local codes.
• In the United States, use the National Electrical Code (NEC);
• In Canada, use the Canadian Electrical Code, Part 1, CSA C22.1;
• In other countries, use International Electrotechnical Commission (IEC) 364,
part 1 through 7.
25. Ensure that the EUM3006 is properly grounded by attaching a grounding cable to the
bolt marked “GND” on the back of the EUM3006. Art. 820-40 of the NEC (US)
provides guidelines for proper grounding and, in particular, specifies that the
grounding cable(s) shall be connected to the grounding system of the building, as
close to the point of cable entry as possible.