E
RROR
! R
EFERENCE SOURCE NOT
FOUND
.
P5186 U
SER
M
ANUAL
V 1.0
Error! Reference source not found.
6 Getting
started
6.1 Procedure
Make sure that both the
“ON/OFF”
switch (
SW201
) and
“BOOT”
switch (
SW202
) are on
position
“OFF”
.
Put the operating configuration switch (
SW200
) in default configuration position:
o
Red jumper on
position 1
,
o
Yellow jumper on
position 3
,
o
Green jumper on
position 5
,
o
Blue jumper on
position 7
.
Make sure that the jumpers
JP500
to
JP507
are connected between
pin 2
and
pin 3
(Main
audio interface and auxiliary audio interface).
Make sure that the external DC power supply is switched off and connect it to
J200
(VBATT)
using the power supply cable provided with the starter kit.
Connect the RS232 cable, provided with the starter kit, between port
COM1
(or
COM2
) of
the PC and
J600
of the
board.
The COM port properties must be the following:
-
Bits per second:
115.200 k
,
- Data
bits:
8
,
- Parity:
None
,
- Stop
bits:
2
,
- Flow
control:
None
.
Connect the antenna to the
SMA300
connector (if communications are required).
Connect the handset, provided with the starter kit, to the Main Audio connector
J500
(if
communications are required).
Insert a SIM card into the SIM card holder (if communications are required).
Switch on the external power supply then adjust:
o
the output voltage to 4 Volts DC,
o
the current limitation to 2 A min.
Switch “
ON”
the
“ON/OFF”
switch (
SW201
) of the board then check there is a consumption
on the external power supply amperemeter.
On the PC, open a terminal emulator window to communicate with the WISMO module via
the COM1 (or COM2) port.
Press the “
RESET”
key (
SW203
) to reset the WISMO module.
Using the terminal emulator, send the following command on COM port to communicate with
the WISMO module:
AT
↵
.
When the communication is established between the PC and the WISMO module, the last
one sends the message
“OK”
as a reply. This
message
is displayed in the terminal
emulator window.
confidential ©
Page :
37 / 42
This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged without prior written
agreement.
Ce document est la propriété exclusive de WAVECOM. Il ne peut être communiqué ou divulgué à des tiers sans son
autorisation préalable.
