Lync WQ-SF
SECTION 2: Installation and Operation
L- OMM-004_A
•
2/23/2022
Technical Support • (800) 433-5654 • Mon-Fri, 8 am - 5 pm EST
6
of
54
Backwash [GPM]
7
12
7
12
Gravel [lbs/tank]
100
100
100
100
Number of Brine Tank
1
1
4
4
Brine Tank Size [in]
24 x 41
30 x 50
24 x 41
30 x 50
Salt Fill [lbs/tank]
700
900
700
900
Electrical Data
5
Voltage [V], Phase, Frequency [Hz]
120, 1Ø, 60
Amps [A]
5/unit
Dimensions w/o Brine Tank(s)
6
Width [in]
75
75
135
136
Depth [in]
38
39
38
39
Height [in]
86
86
86
86
Shipping Weight [lbs]
2000
2200
4200
4600
1. Skid Mounted FRP Top Mount Softener Systems
with Fleck® 2900 1” Drain
2. Service flow rate ranges are presented based on operation at 5 GPM/ft
3
of resin up to peak
flow rate.
3. Flow rates listed above are based on pressure drop only. Selecting a system based on pressure
drop alone does not guarantee that the system will provide adequately softened water. System
selection should be based on resin quantity, capacity required, feed water analysis, and
application requirements.
4. Operation at peak flow rate is not recommended for extended period of time.
5. Electrical data specific to each individual component
6. Skid dimensions do not reflect brine tank space requirements.
1.3.
Feed Water Chemistry Requirements
pH
6 to 10
Hardness (maximum)
Depends on customer's acceptable hardness leakage
level.
Water Pressure
25 psi to 125 psi
Temperature
34 - 110°F (1 - 43°C)
Free Chlorine (maximum)
1mg/L
Iron (maximum)
1mg/L
Oil and H
2
S
None Allowed
Turbidity
Less than 5.0 NTU
Total Dissolved Solids
Must be below 750mg/l for the softener to produce less
than 1 grain per gallon soft water.
Ambient Temperature
34°F/1°C to 122°F/52°C
Water known to have heavy loads of dirt and debris may require pre-filtration prior to the water
softening system. For all other guideline information please contact your Lync representative.
