Lync WQ-SF
SECTION 2: Installation and Operation
L- OMM-004_A
•
2/23/2022
Technical Support • (800) 433-5654 • Mon-Fri, 8 am - 5 pm EST
3
of
54
1.
Introduction
WARNINGS!
Please read carefully before proceeding with installation. Your failure to follow any attached
instructions or operating parameters may lead to the product’s failure. Keep this Manual for future
reference
.
If you are unsure about installing your Lync water softener contact a Lync representative or consult a
professional water treatment dealer or plumber.
You are required to thoroughly read all installation instructions and product safety information before
beginning the installation of this product. FAILURE TO COMPLY WITH PROPER INSTALLATION
AND MAINTENANCE INSTRUCTIONS COULD RESULT IN PRODUCT FAILURE WHICH CAN
CAUSE PROPERTY DAMAGE, PERSONAL INJURY AND/OR DEATH.
Watts is not responsible for damages resulting from improper installation and/or maintenance. Local
building or plumbing codes may require modifications to the information provided. You are required to
consult the local building and plumbing codes prior to installation. If this information is not consistent
with local building or plumbing codes, the local codes should be followed.
Save this manual for future reference.
Refer to the enclosed for operating parameters to ensure proper use with your water supply.
•
As with all plumbing projects, it is recommended that a trained professional water
treatment dealer or contractor install the water conditioning system. Please follow all local
plumbing codes for installing this water conditioning system.
•
Inspect the water conditioning system for carrier shortage or shipping damage before beginning
installation. Replace any damaged component immediately, before beginning installation.
•
Use caution when installing soldered metal piping near the water conditioning system. Heat can
adversely affect the system’s components.
•
Use only lead-free solder and flux for sweat-solder connections, as required by state, province,
and federal codes.
•
Handle all components of the system with care. Do not drop, drag or turn components upside
down.
•
Be sure the floor under the system is clean, level and strong enough to support the system while in
operation.
•
Install the system in a protected area.
•
Do not attempt to treat water over 110°F (43°C) or under 34°F (1°C) with the system.
•
Always connect the system to the main water supply pipe before the water heater.
•
Do not install in direct sunlight as overheating of electronics may occur and ultraviolet rays from
the sun may cause damage.
•
Do not use on water that is microbiologically unsafe or of unknown quality. This system will not
make microbiologically unsafe water safe. Water that is unsafe must be treated separately from
this conditioner.
•
Operating ambient temperature: 34° to 100°F (1° to 43°C).
•
Operating water pressure range: 25 to 125psi (171 kPa to 8.6 bar).
•
All plumbing connections to the system should be made using industry accepted best practices.
Plumbing tape may be used on inlet, outlet and drain connections Do not use paste type pipe
thread sealants on the valve body.
•
Do not use petroleum-based lubricants such as Vaseline, oils or hydrocarbon-based lubricants on
O-rings or valve seals. Use only 100% silicone lubricants.
•
Use only the power transformer supplied with this water conditioning system.
•
All electrical connections must be completed according to local codes.
