SmartPlate Installation, Operation & Maintenance Manual
CHAPTER 8
– CORRECTIVE MAINTENANCE
OMM-0069_0H
• SP-100 • 1/30/2020 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page
69
of
134
OPENING HEAT EXCHANGER Instructions
12. With the tightening bolts removed, the pressure plate can be slid back (Figure 8-10) and
channel heat transfer plates can also be slid back for inspection or cleaning.
Figure 8-10. Heat Exchanger with Pressure Plate Slid Back
8.7.2 REMOVAL AND INSERTION OF PLATES
To remove and insert the channel (heat transfer plates), proceed as follows:
WARNING!
TO AVOID HAND INJURIES WHEN HANDLING PLATES, USE PROTECTIVE GLOVES
.
NOTE:
If defective gaskets are detected during removal of plates, they must be replaced using the
procedures in section 8.8.
REMOVAL AND INSERTION OF PLATES Instructions
1. Push the pressure plate back away from the plate pack.
2. When removing the plates, number or stack them in sequence.
3. Hang the plates with their backs towards the pressure plate (the side without gasket),
unless otherwise specified.
4. Always consult the plate pack numbering or markings to insure the proper plate sequence.
5. Install plates one at a time and push them towards the frame plate (Figure 8-11).
