![background image](http://html1.mh-extra.com/html/watts/aerco-smartplate-ev/aerco-smartplate-ev_installation-operation-and-maintenance-manual_3857645005.webp)
SmartPlate EV Installation, Operation and Maintenance Manual
CHAPTER 1
– GENERAL INFORMATION
OMM-0147_C
• SP-102 • 3/2/2021 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page
5
of
72
GENERAL INFORMATION
1.1 WARNINGS & CAUTIONS
Installers and operating personnel MUST, at all times, observe all safety regulations. The
following warnings and cautions are general and must be given the same attention as specific
precautions included in these instructions. In addition to all the requirements included in this
AERCO Instruction Manual, the installation of units MUST conform with local building codes.
Authorities having jurisdiction should be consulted before installations are made.
IMPORTANT!
This Instruction Manual is an integral part of the product and must be maintained in legible
condition. It must be given to the user by the installer and kept in a safe place for future
reference.
WARNING!
•
Fluids under pressure may cause injury to personnel or damage to equipment when
released. Be sure to shut off all incoming and outgoing water shutoff valves. Carefully
decrease all trapped pressures to zero before performing maintenance.
•
Before attempting to perform any maintenance on the unit, shut off all electrical inputs to
the unit.
•
Electrical voltages
100 to 230
VAC and 24 volts DC
may be used in this equipment.
Therefore, the cover on the unit’s power panel (located behind the unit’s front panel) must
be installed at all times, except during maintenance and servicing.
•
A single-pole switch must be installed on the electrical supply line of the unit. The switch
must be installed in an easily accessible position to quickly and safely disconnect
electrical service. Do not affix switch to unit sheet metal enclosures.