AM Series Pool Heater User Manual
CHAPTER 2: FUNCTION & SPECIFICATIONS
OMM-0111_B:
•
GF-146-P
•
10/29/2019
Technical Support
•
(800) 526-0288
•
Mon-Fri, 8 am - 5 pm EST Page 9 of 47
SECTION 2:
FUNCTION & SPECIFICATIONS
2.1 INTRODUCTION
REFERENCE NOTE:
This manual provides installation instructions for the AM Series Pool Heaters, but not
documentation for all features, such as venting, start-up, operation, or maintenance of the
boiler used in the system. For that information, refer to the AM Series User Manual, GF-146.
Figure 2-1 shows the exterior appearance of an AM Series Pool heating system as it comes
factory configured and installed on a skid. The AM Series Pool Heater comes in four functionally
sized models; the 399, 500, 750, and 1000. Figure 2-2 shows the boilers available.
Figure 2-1: AM Series Pool Heating System (AM 750P / 1000P Shown)
Figure 2-2: Boiler Models Used in AM Series Pool Heating Systems
AM 750P
or
AM 1000P
BOILER
PRESSURE
REDUCING
FILL VALVE
LWCO SWITCH
EXPANSION TANK
PUMP
FLUE OUTLET
OUTLET TO POOL
INLET FROM POOL OR SKIMMER
HEAT EXCHANGER
AM BOILER
SKID
AM 399P
or
AM 500P
BOILER
CONTROL
PANEL
AIR VENT
AIR INLET
GAS INLET
RETURN WATER
TEMPERATURE
SENSOR
