Rear
housing
Depluggable terminal
Front
cover
Ceiling
Spring clips (2)
MOUNTING THE SENSOR
Directly to Ceiling
1. Attach the plastic spring clips to
the edge of the sensor in the slots
provided.
2. Cut a 3.5” to 4” round hole in
the acoustic ceiling tile at the
mounting location. A 3.5” hole is
recommended for a secure fi t.
3. Pull the low voltage wire from the
power pack to the sensor through
the hole.
4. Connect the low voltage wires to
the appropriate terminals on the
sensor.
5. Push the sensor up through the
hole until the Spring Clips hold the
sensor securely in place.
6. Snap the front cover onto the
sensor.
Using an Octagonal J-Box
1. Pull the low voltage wires from the
power pack into the J-Box through
the conduit knockout.
2. Connect the low voltage wires to
the appropriate terminals on the
sensor.
3. Loosen the appliance mounting
screws attached to the J-Box
4. Align the sensor in the J-Box so
that the mounting screws on the
box match the key holes on the
sensor’s rear housing.
5. Push the sensor up into the J -Box and twist it so that the mounting screws are
seated in the keyhole slots.
6. Tighten the two screws to secure the sensor to the J-Box.
7. Snap the front cover onto the sensor.
Ceiling Mount
J-Box Mount
Rear
Housing
Depluggable
Terminal
4" Octagonal J-B
(at least 1.5" dee
Front
Cover
Ceilin
Screws
Call 800.879.8585 for Technical Support