1. Make sure that the power has been turned OFF at the circuit breaker.
2. Connect wires to the DSW flying leads as shown in the wiring diagram below
that is appropriate to the DSW model and electrical supply.
The ground wire
(green) must be fastened to ground for
the sensor to work properly
.
3. Attach the DSW to the wall box by inserting
screws into the two wide holes on the top
and bottom of the attached metal bracket.
Match them up with the holes in the wall
box and tighten.
4. Turn the circuit breaker
ON. Wait one minute,
then push the ON/OFF
button for each load and
the lights will turn ON.
There is a delay due to
initialpower-up of the
sensor that only occurs
during installation.
5. Test and adjust the sensor
INSTALLATION
DSW-302 and DSW-302-347
Bi-Level Wiring
DSW-302 and DSW-302-347
Dual Circuit Wiring
WARNING
TURN THE POWER OFF AT THE CIRCUIT BREAKER
BEFORE INSTALLING THE SENSOR OR WORKING ON THE LOAD.
#12 — #14 AWG
Cu Wire Only
Strip Gage
1/2"
12.7mm
Load
Red
Black
Neutral
Line
Green
Green
Neutral
(optional)
Ground
Yellow
DSW-301 and DSW-301-347 Wiring
Red
Black
Neutral
Line
Green
Green
Ground
Blue
Primary
Load
Secondary
Load
Neutral
(optional)
Brown
Yellow
Red
Black
Neutral
Line 1
Green
Green
Ground
Blue
Primary
Load
Brown
Secondary
Load
Line 2
Neutral
Neutral
(optional)
Yellow