Document #10-32813 Rev A; June 07, 2019
Page
31
of 69
System Configuration Settings
System settings are stored in the Setup.csv file on the NOR FLASH drive, which you can view in CSV Creator. To con-
figure these system settings:
1.
Clear or save any previous data shown in the data table.
Figure 30: Clear Data Button
2.
Select
Setup
from the File Type dropdown menu.
Figure 31: Select Setup from the File Type Menu
3. If it is not already mounted, mount the NOR Flash Drive to your PC using the
Mount NOR
button. (When the
device is mounted, this button will be green. The status bar will also be green and will state the drive letter rep-
resents the NOR FLASH drive on the PC).
4. Select the
Load from RMA PLUS
button.
Figure 32: Load from RMA PLUS Button
Note: Do not corrupt this setup.csv file or your RMA PLUS will not operate correctly.
Data Log Configuration
CSV Creator may be used to configure data logging for the RMA PLUS. The parameter selection available is the same
as shown for the Modbus® configurations above. Parameters for the RMA PLUS and all connected devices will be avail-
able for data logging. Like on the Modbus® table, all parameters to the right of the description column will only be shown
on the initial load of the parameters from the device, as they are not saved in the file.
