Watlow PM PLUS™ 6
•
42
•
Chapter 4: Operations
Adding Custom Parameters to the Operations List
Up to 20 custom parameters can be added to the Operations List. The parameters available for selection vary
depending on the configuration code of your device. Refer to your product label for the configuration code.
1. Navigate to:
Operations — Factory — Custom Setup — Custom Setup [1-20] — Parameter
2. Scroll to and select the parameter to display. Refer to table: "Operations List - Custom Parameter Options."
Operations List - Custom Parameter Options
All Models
Analog Input Value (Instances 1 or 2)
Cal In Offset (Instances 1 or 2)
Display Units
Load Parameter Set (Instances 1 or 2)
Alarm Low Set Point (Instances 1, 2, 3, or 4)
Alarm High Set Point (Instances 1,2, 3, or 4)
Alarm Hysteresis (Instances 1, 2, 3, or 4)
Additional Parameters Available if 4th digit of configuration code is T
Time Remaining
Ready Band State
Ready Band
Closed Loop Timer Set Point
Hours
Minutes
Seconds
Additional Parameters Available if 4th or 9th digit of configuration code is L or M
Limit Set Point Low
Limit Set Point High
Limit Hysteresis
Limit Status
Additional Parameters Available if 4th digit of configuration code is B, E, C, R, J, or N
Set Point (Instances 1 or 2)
Active Process Value (Instances 1 or 2)
Active Set Point (Instances 1 or 2)
Manual Power (Instances 1 or 2)
Autotune (Instances 1 or 2)
Control Mode (Instances 1 or 2)
Heat Power (Instances 1 or 2)
Cool Power (Instances 1 or 2)
Time Integral (Instances 1 or 2)
Time Derivative (Instances 1 or 2)
