Watlow PC1X-F20, User Manual

Page: 44 / 73

Active if communications is
installed.
Active if [glbl] is set to [`Off] .
869 r/w
[`std]
active (0)
[`std] active (0)
[`LaT] latched (1)
[`SIl] silenced (2)
[LaSI] latched and
silenced (3)
[C|wd] Comms Watchdog
Alarm Config.
Selects the commu-
nications watchdog
alarm configuration.
Active if [glbl] is set to [`Off] . 868 r/w [`std]
active (0)
[`std] active (0)
[`LaT] latched (1)
[`SIl]
silenced (2)
[LaSI] latched and
silenced (3)
[``OU] Over Voltage
Alarm Config.
Selects the line over-
voltage alarm config-
uration.
Active if [glbl] is set to [`Off] . 867 r/w [`std]
active (0)
[`std] active (0)
[`LaT] latched (1)
[`SIl] silenced (2)
[LaSI] latched and
silenced (3)
[``UC] Voltage Compensa-
tion Alarm Config.
Selects the line com-
pensation alarm con-
figuration.
Active if
[glbl]
is set to
[`Off]
.
866 r/w [`std]
active (0)
[`std]
active (0)
[`LaT] latched (1)
[`SIl] silenced (2)
[LaSI] latched and
silenced (3)
[Freq]
Frequency Out of
Tolerance Alarm
Configuration
Select frequency tol-
erance alarm config-
uration.
Active if heater diagnostics is
installed.
Active if controller is 3 phase.
991 r/w
[`100] (100) [```0] to [`100]
(0 to 100)
[Ldif] Load Balance
Percentage
Selects the mini-
mum percentage
difference between
loads current in
phases.
Active if heater diagnostics is
installed.
Active if [glbl] is set to [`Off] .
Active if controller is 3 phase.
865 r/w [`std]
active (0)
[`std] active (0)
[`LaT] latched (1)
[`SIl] silenced (2)
[LaSI]
latched and
silenced (3)
[Lbal] Load Balance
Alarm Config.
Selects the load
balance alarm
configuration.
Active if controller is 3 phase, 3-
leg configuration.
Active if [glbl] is set to [`Off] .
864 r/w [`std]
active (0)
[`std] active (0)
[`LaT] latched (1)
[`SIl] silenced (2)
[LaSI] latched and
silenced (3)
[p|bAl] Phase Balance
Alarm Config.
Select phase balance
configuration.
P a r a m e t e r s , C h a p t e r 6 Wa t l o w P o w e r S e r i e s
■
6 . 1 1
NOTE: For more information about how parameter settings affect the controller’s operation, see Chapter Five, Control
Methods and Features.
Display Parameter Range Default Modbus Conditions for
(Modbus Value) Address Parameters to Appear
read/write