Watlow Anafaze PPC-2000, User Manual, Page: 232 / 320

Chapter 5: LogicPro and Modbus Reference PPC-2000 User’s Guide
204 Watlow Anafaze Doc.# 30002-00 Rev 2.3
Table 5.43 Addresses for Analog Outputs on the
PPC-205x Analog Out Modules
1
The AnaWin3 names are shown for the first PPC-2000 in the system. See
Outputs on page
135 for a full explanation of analog output naming.
2
Use this address with the Analog_Out_205x IO Driver when addressing
Analog Output Value
.
There are no other analog output parameters so you will not use the Database IO Driver.
Analog Output Value
An array of addressable I/O words that represent the output
value for each analog output as a number between 0 and 32767.
These numbers correspond to the minimum and maximum
output signal levels for the selected
Output Type
. The analog
signal range is determined by the hardware, jumper
configuration, and the setting of the
Output Type
for the channel
with the output selected as
Heat/Cool Output Destination
.
Range: 0 to 32767
NOTE!
The resolution of the analog outputs is 12 bit. The
output Value is displayed as a 15-bit integer. The
output Value must change by more than seven to
effect a measurable change in an analog output.
AnaWin3 Name
1
(Output Spreadsheet)
LogicPro I/O Physical
Address
Modbus Addressing
Analog_Out_205x
IO Driver
2
Decimal Hex
PPC1:AO 31.1
PPC1:AO 31.2
PPC1:AO 31.8
31.1
31.2
31.8
46267
46268
46274
187A
187B
1881
PPC1:AO 32.1
PPC1:AO 32.2
PPC1:AO 32.8
32.1
32.2
32.8
46275
46276
46282
1882
1883
1889
PPC1:AO 33.1
PPC1:AO 33.2
PPC1:AO 33.8
33.1
33.2
33.8
46283
46284
46290
188A
188B
1891
PPC1:AO 34.1
PPC1:AO 34.2
PPC1:AO 34.8
34.1
34.2
34.8
46291
46292
46298
1892
1893
1899
… … … …
… … … …
… … … …
… … … …