34
WATLOW Series 942 User's Manaul
Programming, Chapter 5
RUN Menu
NOTE:
Shaded parame-
ters may not
appear on your
control. These
parameters are
dependent on how
your control is
configured.
Figure 36 -
The Run Menu.
= MODE Key
= HOLD/RUN Key
= UP/DOWN Key
HOUr
MIn
SEC
rAtE
Ent1
Ent2
EJC
[SP]
EnSP
StP
rESU
Step (# to start at)
Resume (step #)
Current Set Point
End Set Point
Hour remaining
Minutes remaining
Seconds remaining
Rate
Event 1
Event 2
Elapsed jump count
rtn
Return
( )
( )
( )
( )
( )
( )
( )
( )
( )
( )
( )
M
Running a Series 942 Profile
You can run your Series 942 profile from anywhere except the Setup menu. Press
the HOLD/RUN key. The RUN LED begins flashing, and the lower display flashes
and asks what StP (step) to begin on. Use the UP/DOWN key to enter the step
and press the HOLD/RUN key once again, your profile begins, and the RUN LED is
lit. If the HOLD/RUN key is not pressed twice within 1 minute, the RUN function
will abort.
While the profile is RUNning, you can only view the RUN menu.
Press the MODE key to advance you through the RUN menu. For more informa-
tion on Pout (power outages) see Page 25.
Resume a Profile
To resume a halted profile, press the HOLD/RUN key once. Press the MODE key
to advance to the rESU parameter, and press the HOLD/RUN key again, the
profile resumes, and the RUN LED is lit. You can only resume at the
exact
step
you left off on. If you halt a running profile and make changes, you
cannot
resume
running. The rESU parameter only appears when a running profile is halted.
H/R
M
To
Run
your profile...
Press the
key twice.
To
Stop
a running profile...
Press the
key once.
To
Resume
a halted profile...
Press the
key, press the
key to advance to the rESU parameter, and press the
key.
H/R
M
H/R
H/R
H/R
