Watlow Controls Series 998, User Manual

Page: 41 / 126

WATLOW Series 998 User’s Manual
4.13 Setup Menus, Chapter 4
Calibration Offset 2
Offset the channel B signal by a positive or negative value. This allows
you to compensate for lead resistance, sensor errors or other factors.
[CAL2] This prompt appears only if [`In2] is not set to [``no] .
If Default
↓ ↓
[``°F] [-999] … [```0] … [`999]
[`C_F] [CAL2] [CAL2] [CAL2]
(Global Menu)
[``°F]
&
[`r†d] [-9(9] … [``)0] … [`9(9]
[`C_F] [`In2] [CAL2] [CAL2] [CAL2]
(Global Menu) (Input Menu)
[``°C] [-555] … [```0] … [`555]
[`C_F] [CAL2] [CAL2] [CAL2]
(Global Menu)
[``°C]
&
[`r†d] [-5%5] … [``)0] … [`5%5]
[`C_F] [`In2] [CAL2] [CAL2] [CAL2]
(Global Menu) (Input Menu)
[-999] … [```0] … [`999]
units
a process input
[CAL2] [CAL2] [CAL2]
is selected
RTD Calibration Curve 2
Select the calibration curve for the channel B RTD 2 input. The RTD
input uses either the European (DIN, 0.003850
Ω
/
Ω
/°C) or the Japanese
(JIS, 0.003916
Ω
/
Ω
/°C) linearization standard.
[rtd2]
This prompt appears only if you have set
[`In2]
to
[`rtd]
or
[`r†d] .
Default
↓
[`din] [`JIS]
[rtd2] [rtd2]
Setup-Input
[CAL2]
[rtd2]