Watkins Wellness UPRITE, Installation Manual

Page: 8 / 16

7
UPRITE COVER LIFTER INSTALLATION
STEP 2
ATTACH SIDE ASSY. CHANNEL
STEP 3
ATTACH EXTENSION TUBE TO COVER
E
2X
Figure 4.1
S
R
M
4X
1. Locate previously mark made over the
aluminum plates of the side of the cover
set. Align mark on the side Side Assembly
Channel (C) to the mark made on the side of
the cover set (Figure 3.1).
2. Using the (4) holes on the side Assembly
Channel as a template, mark the location of
the (4) holes (Figure 3.1).
1. Locate both Right Extension Tube (E)
and Left Extension Tube (M). Assemble
Extension Tubes and Angle Brackets as
shown in (Figure 4.1).
1. Pre-Drill holes 1/8” (3mm) by 1/2” (12.5 mm)
max depth (Figure 3.1).
All (4) holes must be positioned over the
aluminum plate, which is located under
the Vinyl.
NOTE
Figure 3.2
C
R
4X
D
Figure 3.1
Z
C
Repeat this step on the Right side of cover.
1. Make sure to align Channel (C) and Spacer
(Z), secure Side Assembly Channel (C) to
cover set using (4) 1-1/2” Flat Head Screws
located in Bag #1 (Figure 3.1) Make sure
screws are seated completely into the
countersunk holes of the Side Assembly
Channel (C)
Spacers (Z) will be required in the following
steps. Spacers (Z) are provided in Bag #5.
NOTE
All spacers come with pre-drilled holes
NOTE
4
3
1. Locate the (Left) Extension Tube Assembly
(Green dot = Left, Red dot = Right)
2. Slide the (Left) Extension Tube Assembly into
the Side Assembly Channel (C) (Figure 4.1).
2
3