RENEGADE GUNITE SKIMMER OPERATING INSTRUCTIONS
NORMAL OPERATION
Water passes over the weir door, down through the basket and float valve assembly to
the pump. The trimmer plate on the float valve assembly or the diverter plate are both
open.
ADJUSTING THE SKIMMER FLOW
If the skimmer flow is too fast due to excessive flow rate from the pump, either rotate
the float valve trimmer plate or the diverter plate over the port to the pump until
required flow is achieved.
VACUUM/BRUSHING THE POOL
To vacuum the pool, first remove the float valve, then close the diverter plate over the
main drain. Install the vacuum plate above the basket and connect the vacuum hose
to the vacuum plate to proceed with the brushing operation.
MULTIPLE SKIMMERS
Rotate the diverter plate at the bottom of the skimmer over the pump port to restrict
the flow and balance the flow from each skimmer.
LOW WATER LEVELS
When the water level drops below the weir door, water will no longer flow from the
pool through the upper part of the skimmer. The pump will evacuate the remaining
water from the skimmer causing the float valve to close and water will flow from the
main drain only, or until the water level is increased. The same can occur when and if
the basket gets filled with leaves and debris.
RENEGADE GUNITE SKIMMER REPLACEMENT PARTS
Replacement Weir Door
550-9950 White
550-9951 Black
550-0057 Gray
550-9959-DKG Dark Gray
550-9959-BEI
Beige
(bagged individually)
Extension Ring
519-6570 White
Float Valve Assembly
542-6200 White
Equalizer Valve
540-6010
Lid Assembly
540-6460WW White
540-6467WW Gray
540-6469WW-B Beige
Vacuum Plate
519-6480
Diverter Plate & Screw
519-6470
819-4350
Mounting Ring
519-6420 White
519-6427 Gray
519-6429-BEI Beige
Skimmer Basket
542-3240 White
810-0054.0618
©2018 Waterway Plastics
2200 East Sturgis Road, Oxnard CA 93030 • Phone 805.981.0262 • Fax 805.981.9403
www.waterwayplastics.com • [email protected]
Designed,
Engineered &
Manufactured
in the USA.
