INSTALLATION INSTRUCTIONS
HUNLEY SERIES KITCHEN FAUCETS
3600-XX
Before you begin your installation:
1.
Make sure your water supply is turned off
2.
Observe all local plumbing codes
3.
Inspect waste and water supplies for any signs of
damage and replace as necessary
4.
Do not use petroleum based products on this faucet.
Recommended Tools and Materials
1.
Phillips Screwdriver
2.
Adjustable Wrench
FAUCET INSTALLATION (see diagram)
1.
Remove the clamp nut (A) and washer (B) from the threaded
shroud (C) under the faucet and fit the faucet flexible
hoses and rigid sidespray tube through the hole on the
counter or sink. (No plumbers putty is required in that the
faucet has an O-ring seal built into its base).
2.
Slide the washer and thread the clamp nut onto the threaded
shroud. Make sure clamp screws are screwed back and
thread the nut snug to the underside of the sink or counter.
3.
Make sure the faucet is in the correct position you want it for
your sink and securely tighten the clamp screws.
CONNECT SUPPLY HOSES
1.
Carefully position the hot and cold supplies so they will not
interfere with other hoses
2.
Connect the supply hoses to the supply stops
