Cleaning the extraction cone
March 14, 2014, 715004387 Rev. B
121
Removing the extraction cone from the ion block
Required materials
•
Chemical-resistant, powder-free gloves
•
Combined 2.5-mm Allen wrench and cone extraction tool
To remove the extraction cone from the ion block:
1. On the rear of the ion block, use the combined 2.5-mm Allen wrench and
cone extraction tool to loosen the captive screws securing the 2 PEEK
extraction cone retainer clips, and then rotate the retainer clips clear of
the extraction cone.
Warning:
To avoid personal contamination with biohazards or
toxic materials, and to avoid spreading contamination to
uncontaminated surfaces, wear clean, chemical-resistant,
powder-free gloves when working with the ion block components.
Securing screw
Extraction cone
Retainer clip
rotated clear of the
extraction cone
Extraction cone handle insulator
Summary of Contents for Xevo TQD
