Figure 3–1: Column manager control panel
The following table describes the items in the column manager's control panel:
Run LED
- Mirrors the run status LED on the column manager's front panel, unless
communications are interrupted.
Column currently in use
- Displays the column that is currently in use.
Current temperature
- Displays the current column compartment temperature.
Temperature set point
- Displays the column compartment set point. When active
temperature control is disabled, this field displays "Off".
You can access these additional functions by right-clicking anywhere in the column manager
control panel.
Table 3–4: Additional functions in the column manager's control panel
Control panel function
Description
Reset CM
Resets the column manager after an error condition.
Help
Displays the console online Help.
3.6.2 Sample manager control panel
The control panel of the sample manager-flow through needle (SM-FTN) displays the current
temperatures of the sample compartment and column heater, their set points, and the selected
column.
You can edit these values when the system is idle by clicking the underlined value. You cannot
edit sample manager set points while the system is running samples.
April 4, 2018, 715005702 Rev. A
Page 53