2 Preparing for Operation
40
September 26, 2013, 715004208 Rev. A
Installing the waste tubing and vent tubing for the
degasser
To install the tubing:
1. Wet the barbed drain fitting at the bottom of the ISM with methanol.
2. Hold the back of the drain cup, slide the waste tubing over the barbed
drain fitting, and route the tubing to a suitable waste container.
Caution:
To prevent contamination and possible contact with
solvent, wear clean, chemical-resistant, powder-free gloves when
installing or removing the waste and degasser vent tubing.
Caution:
To avoid distorting the drip tray or causing the drain cup
to leak, restrain the drain cup when attaching or removing the
waste tubing.
Barbed drain fitting
Drain cup
Drip tray