WATERKOTTE EcoTouch Ai1 Geo, Planning And Installation

Page: 6 / 60

Safety
12.11.2015
6 / 60
Z21826
Copyright

2013 by: WATERKOTTE GmbH. Subject to changes
1 Safety
1.1 Intended use
Your WATERKOTTE heat pump is used for space heating and cooling, and heat-
ing of domestic water.
Project planning of the heat source system must be performed in compliance with
the technical information provided by WATERKOTTE for layout of heat source sys-
tems.
Heat pump shall only be turned on after the refrigerant connections are completely
filled, and the other hydraulic circuits are completely filled and vented, and all elec-
trical connections are properly completed.
Commissioning may only be carried out by trained professionals. Damages
caused by non-compliance with above mentioned items are not covered by the
warranty (see enclosed Exclusion of Warranty).
Risk of total loss!
The device may only be switched on when the hydraulic circuits are completely
filled and vented, and all electrical connections are properly.
The commission may only be performed by trained specialist staff. Damages
resulting from failure to observe the points above , are not in the scope of the
warranty (see attached warranty- exclusion).
1.2 Basic safety precautions
1.2.1 Keep information available
In addition to the operating manual, also furnish operating instructions in terms of
Labour Protection Law and Work Equipment ordinance.
Keep all safety and operating signs on the heat pump in fully legible condition at all
times. Replace damaged or illegible signs immediately.
1.3 Before initial use
Before initial use of your WATERKOTTE heat pump, familiarise yourself with:

Operating and control elements of your WATERKOTTE heat pump

Equipment of heat pump

Operation of heat pump

Immediate surroundings of heat pump

Safety devices of heat pump
Before initial start, perform the following steps:

Ensure that all safety devices are installed and function as intended.

Check heat pump for visible damage. Remedy any detected defects immedi-
ately. Heat pump must be in perfect condition during operation!

Ensure that only authorised personnel is in the work area of the heat pump
and that no other persons are endangered when heat pump is started.