Page
10
of
12
5
6
Under-Voltage
Recovery
voltage protection, the output of the load will be
recovered as soon as the battery voltage recovers to
higher than the under-voltage value. Hold the Left-Hand
Side Button for more than 5 seconds
，
numbers start
flashing.
To change the values, Left Hand Side Button, increases
the setting value or Right Hand Side Button reduces the
setting value.
To Enter/Save the setting interface of recovery after
undervoltage; Hold the Left-Hand Side Button for more
than 5 seconds (The numbers stop flashing). Setting
value will be conserved by controller.
Under-Voltage Recovery
Turning the Load ON
and Turning the
Load OFF state
As shown in the display picture at the right, the interface
of load mode is displayed, and different numbers
represent different load modes.
24 H represents Normal Mode; the load is always in
power under the fault-free circumstance.
1 H to 23 H represents a Light Sensor Control together
with a Time Control Mode. When in this mode (1 H
–
23
H), the controller will switch ON the load after darkness
and will Turn the load OFF the load after the amount of
the set hours has elapsed.
0 H represents Light Control Mode; Load will switch ON
after darkness (Sunset) and then the Load will be
switched OFF at dawn (Sunrise).
Hold the Left-Hand Side Button for more than 5 seconds,
the numbers start flashing to activate the setting interface
of load working modes and use the Right-Hand Side or
Left Hand Side buttons to increase or decrease to adjust
the parameter; Hold the Left-Hand Side Button for more
than 5 seconds again. The numbers stop flashing and the
setting value will be conserved by controller.
the Load ON and Turning the
Load OFF state
Viewing and setting
of battery types
As pictured at right, different numbers represent
different types of Battery.
b00
：
Lithium battery (other controls parameters need
to be adjusted to match the battery)
b01
: Sealed battery (default type for the controller)
b02
: Vented battery
b03
：
Gel battery
Hold the Left-Hand Side Button for more than 5 seconds
，
numbers start flashing
）
at this interface to activate
the battery type and use the Left Hand Side Button or
the Right hand side button to adjust the parameter;
Hold the Left-Hand Side Button for more than 5 seconds
The numbers stop flashing. Setting value will be
conserved by controller.
Errors / Problems and Issues
Error / Issue
Remedy
