Operation of Multi Function Electronic
Control Panel
The temperature display of the electronic control panel is factory set to show pool water
temperature in degrees FAHRENHEIT. See
“To select temperature in ˚C or ˚F”
section on
the following page.
To Start The Pool Heat Pump
When the pool heat pump is turned
“ON”
or after a power shut down, the panel lights up
and either indicates
“OFF”
or the temperature of the pool water circulating inside the pool
heat pump.
When the unit is first turned on and water is flowing, the fan motor will start (blades will
turn) followed by the compressor 3 to 5 minutes later. ( the compressor and fan may start
together when the unit has automatically cycled off for a period of time and then restarts)
To Stop The Pool Heat Pump
The pool heat pump can be stopped by switching off the electrical power supply or by
setting the desired water temperature setting to below 60˚F (15˚C).
Actual temperature and setting display
Pool Mode
Compressor running
Spa Mode
To toggle
between
functions
To lower desired temperature or
to change settings
To raise desired temperature or
to change settings
