OVERTEMP message
depending on the amount of power provided by the USB port. The camera charges significantly
faster when docked in a USB Base plugged into an electrical outlet.
Caution:
To prevent possible damage to some computers, connect the USB
Base to the computer through the approved USB hub (Sabrent 7-Port USB 2.0
Hub, WatchGuard part number WGP02364).
If the camera is docked in a Transfer Station, move the camera to another slot in the Transfer
Station. If the camera continues to read
LOW BASE
in the Transfer Station, contact
WatchGuard Customer Service.
OVERTEMP message
The
OVERTEMP
message appears on the display when the camera (VISTA and VISTA WiFi) or
DVR (VISTA XLT) is docked, but the battery is unable to charge due to excessive heat. The
camera will continue to try to charge as it cools down.
Important!
Battery charging shuts down at ambient temperatures greater
than 35 degrees C (95 degrees F).
Tip:
For the best battery life and fastest charging times, WatchGuard
recommends that you charge the VISTA Body Camera in a cooler environment.
Wi-Fi
Note:
Not all VISTA Body Cameras or VISTA bases have the Wi-Fi® feature. If
you are not sure whether your equipment has Wi-Fi, contact your WatchGuard
representative.
The VISTA WiFi and VISTA XLT cameras include built-in Wi-Fi (802.11n).
Note:
VISTA WiFi and VISTA XLT also include GPS capability. For more
information, see GPS on
.
The Wi-Fi feature allows VISTA WiFi and VISTA XLT to pair with the VISTA WiFi Base. Once the
camera and the base are paired, the camera is associated with the local recording group. For
more information about pairing VISTA WiFi and VISTA XLT with the WiFi Base, see
and VISTA XLT: Associating with a recording group
.
The Wi-Fi feature also allows VISTA WiFi and VISTA XLT to operate as a Wi-Fi access point
(hotspot) for the VISTA SmartConnect smartphone application.
VISTA Body Camera
WGD00120 Revision
ReviewDraft_111518
61
