Mobile Charger base
Mobile Charger base
The VISTA Body Camera slips into the base with a click. Do not tilt the camera when inserting it.
Ensure that you insert the camera with the front of the camera facing the same way as the
WatchGuard logo on the front of the mobile charger.
To remove the VISTA Body Camera from the Mobile Charger:
1. Gently pull one wing of the charger base outward from the camera.
2. Rock or tilt the Mobile Charger base away from the camera.
Mobile Charger cable
The 12V cigarette-lighter plug for the mobile charger has a 3-amp fuse built in. This fuse may or
may not be higher than what your vehicle electrical panel is configured with. The cable has no
limiting mechanism so it will draw the maximum current the supply can provide if shorted.
This can cause the fuse to blow in the lighter plug of the cable or in the vehicle electrical
distribution box. If this happens:
1. Check your vehicle distribution box.
a. If the fuses are 3A or smaller, replace these before replacing the Mobile Charger cable fuse.
b. If the fuses are greater than 3A, replace the Mobile Charger cable fuse.
WatchGuard recommends the Littelfuse 312003P (part number WGP02649). This is a
250 V, 3A, Fast Acting Fuse. The fuse size is 3AG.
2. Replace the fuse in the Mobile Charger cigarette-lighter plug.
a. Grasp the lighter plug.
b. Unscrew the contact end.
The fuse comes out when you fully unscrew the end and pull it out.
c. Replace the existing fuse with a 3A fuse and reinsert it into the lighter plug.
VISTA Body Camera
WGD00120 Revision
ReviewDraft_111518
109
