HiFi Microphone
The mic and the base in the vehicle sync automatically when you place
the mic in the powered base for a few seconds. To sync the mic with the
base:
1. Power the DVR on and verify it is ready to use.
2. Power the mic on (see
).
3. Place the mic into the base.
The LEDs on the mic and the base flash and the mic beeps as the pair
syncs.
Note:
Once the mic and base are synced, either
the green LEDs turn on (the mic is ready to use)
or the red LEDs start flashing (the mic needs
charging). For information on charging the mic,
see Charging the Transmitter below.
4. Remove the mic from the base and verify their connection on the mic's
display (see
).
Charging the Transmitter
The battery in the transmitter (mic) must be charged before you can use
the HiFi Microphone (HiFi Mic). The base (either the vehicle base or the
charge-only base) serves as the charger for the mic.
To charge the mic:
1. Power off the mic (see
).
2. Place the mic in a base.
Note:
WatchGuard Video recommends that you power
off the mic before you put it in the base to charge, but
this step is not required.
If the base is in the vehicle, the base syncs with the mic before the mic
begins to charge. (For more information about syncing the mic and the
base, see
Synchronizing the Transmitter and the Base
.) If
the base is a charge-only base, usually used inside your office, the mic
begins charging immediately.
30
WGD00091
Revision F
