Watchguard 4RE, User Manual

Page: 88 / 118

Working as 4RE DVR Administrator
l
Setting camera auto-zoom (page 56)
l
Modify crash sensitivity (page 56)
l
Verify 4RE DVR network information (page 93)
l
Install the 4RE configuration file
See your Evidence Library software documentation.
Deploying a configuration
Deploy a 4RE configuration manually or automatically. Always deploy manually in the following
situations:
l
First time a configuration is loaded on a 4RE DVR
l
Your agency does NOT use a wireless network to connect to its fleet of 4RE DVRs
In all other situations, you deploy a 4RE configuration automatically through your wireless
network, if available. Anyone with a supervisor password can deploy the 4RE configuration. For
instructions about how to deploy a 4RE configuration manually,
see Configuring a DVR with the
USB thumb drive on page 90
Updating 4RE firmware
As new hardware and software features are developed, you may need to update your systems.
WatchGuard Customer Service can tell you the latest software version available.
Note: WatchGuard recommends that you maintain the same level of firmware
across your 4RE fleet.
You can update the 4RE system in two ways, depending on your agency setup:
l
Install the updates wirelessly
l
Install the updates with the USB thumb drive
Anyone with a Supervisor password can update the software.
Updating wirelessly
Updates can be stored in Evidence Library and then transferred to the 4RE DVR as a unit comes
into wireless range. This update takes place automatically if the Evidence Library software is set
up to push the updates out to the vehicle 4RE DVRs. The officer needs to do nothing and the
update takes effect the next time the unit is rebooted. When successfully updated, the system
displays a message at start-up that it has been upgraded to a new version.
See your Evidence Library software documentation for instructions about automatically
installing a 4RE DVR software update.
88 4RE In-Car Video User Guide 4.0.6
WGD00089 Revision D