Wasp WWS650, Product Reference Manual

Page: 207 / 316

Symbology Selection Enter/Exit Programming Mode
Product Reference Guide 197
Micro PDF417 Set Length 2
This feature specifies one of the bar code lengths for Micro PDF417 Length Control on page
196 . Length 2 is the maximum label length if in Variable Length Mode, or the second fixed
length if in Fixed Length includes the bar code’s data characters only. Characters can be set
from 0001 to 0366 characters (pad with zeroes) in increments of 01. Any value greater than
0366 will be considered to be 0366.
See
page 245 for detailed instructions on setting this feature.
$CMIL2
Select Micro PDF417 Length 2 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad
representing
your desired character(s). End by scanning the ENTER/
EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
Length 2 is 0366 Characters