Data Editing
4-6
DuraLine™ 2D Imagers
User Specified Intercharacter Delay
An intercharacter delay of up to 495 milliseconds may be placed after the
transmission of a particular character of scanned data. Scan the Delay
Length bar code below, then scan the number of milliseconds and the
SAVE bar code using the
of this manual.
Next, scan the Character to Trigger Delay bar code, then the 2-digit hex
value for the ASCII character that will trigger the delay
Chart (Code Page 1252) on page A-4
To remove this delay, scan the Delay Length bar code, and set the num-
ber of steps to 0. Scan the SAVE bar code using the
of this manual.
Interfunction Delay
An interfunction delay of up to 495 milliseconds may be placed between
the transmission of each segment of the message string. Scan the Inter-
function Delay bar code below, then scan the number of milliseconds
and the SAVE bar code using the
of this
manual.
To remove this delay, scan the Interfunction Delay bar code, then set the
number of steps to 0. Scan the SAVE bar code using the
of this manual.
Delay Length
Character to Trigger Delay
Interfunction Delays
Prefix
Scanned Data
Suffix
1
2 3 4 5
STX
HT
CR
LF
Interfunction Delay
Summary of Contents for 2D
