Product Reference Guide
11-1
Chapter 11
Serial Programming
Commands
Serial Programming Commands
The serial programming commands can be used in place of the program-
ming bar codes. Both the serial commands and the programming bar
codes will program the DuraLine 2D. For complete descriptions and
examples of each serial programming command, refer to the correspond-
ing programming bar code in this manual.
The device must be set to an RS-232 interface (see the Quick Reference
Guide). The following commands can be sent via a PC COM port using
terminal emulation software.
Conventions
The following conventions are used for menu and query command
descriptions:
parameter
A label representing the actual value you should send as part of
a command.
[
option
]An optional part of a command.
{Data}Alternatives in a command.
bold Names of menus, menu commands, buttons, dialog boxes, and
windows that appear on the screen.
Summary of Contents for 2D
