Warrior Products, Inc.
11100 SW Industrial Way
Tualatin, OR 97062
Phone: (888) 220-6861
Fax: (503) 692-0364
QUALITY
●
INTEGRITY
●
INNOVATION
●
SERVICE
2005
–
2017 Toyota Tacoma Platform Roof Rack
–
Double Cab
P/N 4860
Kit Contents:
Item
Qty
Item
Qty
3/8” x 1”
Hex Bolt
8
Platform Rack
1
3/8”
SAE Flat Washer
16
6mm x 20mm Bolt
8
3/8” Nyloc Nut
8
1/4
” Lock Washer
(use w/ 6 MM)
8
Mounting Bracket
2
1/4”
USS Flat Washer (use w/ 6 MM)
8
Installation Instructions:
1.
If you have a factory roof rack, remove it to reveal the factory roof rack mounting points.
2.
If you do not have a factory roof rack, remove ditch moldings by using a tape-wrapped flathead screwdriver or
some other soft, flat edge. See
Figure 1
. This will reveal 10 well
nuts (5 driver’s side & 5 passenger’s side).
3.
Remove protective tape from the 2 front-most well nuts and 2 rear-most well
nuts. Do this on both the driver’s
side and the passenger’s s
ide.
4.
Use some RTV silicone sealant around each of
the well nuts, to prevent rusting and water leaks.
5.
Locate your mounting brackets. These will have
tabs and a lip facing inwards with a stamped
“WP” towards the rear of the vehicle.
6.
Starting with the driver
’s side, position the
mounting bracket and loosely attach to the 4
well nuts using the 6mm x 20mm bolts
, ¼” Lock
Washers, and ¼” USS Flat Washers
.
7.
Tighten bolts (torque is approx. 8 ft-lbs). Repeat
step 6 for the passenger side.
8.
Place the platform on mounts with the angled
platform tube facing forward. It helps to have a
spare set of hands for this step.
9.
Loosely start [4] 3/8” x 1” bolts
, [8] washers, and
[4] Nyloc Nuts. The bolts should be placed in
through the center row of slots(Front-to-Rear),
and in the two inner-most slots (Side-to-Side).
See
Figure 2
. **To clear the factory Sharkfin
Antenna you may have to place the bolts in the
Front row of slots (platform slid back).**
10.
Repeat step 10 for opposite side.
11.
Visually align platform and tighten all hardware.
12.
Installation Complete.
Figure 1
Figure 2
3/8”
Bolt Locations
*Front-to-Rear: Centered
*Side-to-Side: Inside Slots
