Protecting Your Adventure Lifestyle
============================================================================================================
QUALITY
●
INTEGRITY
●
INNOVATION
●
SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
Factory Fog Light Bucket assembly and Installation
P/N 4500-2
Kit Contents:
Item
Qty
Item
Qty
Factory Fog Light Bucket
2
#10-32 KEPS Nut
16
Light Mount Bracket
4
Rubber Edge Trim
30”
Fog Light Removal Instructions:
1.
First, remove the fog lights from your factory
bumper skin.
2.
Release the Adjustment Post by gently
compressing two tabs and push the post
through the hole. See
Figures 1 & 2
.
3.
Next, using a flathead screwdriver, gently pry
out on the retaining tab on the outside of the
light housing to release the light. The fog light
will come out through the front of the bumper
skin. See
Figure 3
.
4.
Repeat the procedure to remove the second light.
Light Bucket Assembly Instructions:
5.
Remove the bulb from the fog light and
screw the adjustment post all the way
in to provide enough clearance for the
light to slide into the side of the Light
Bucket. See
Figure 4
.
6.
Verify that all four Light Mount
Brackets will fit over the side Pivot Post
of your fog lights. See
Figure 5
. The
hole may be tight due to variations in
powder coat thickness. Enlarge the hole slightly using a round file, or drill bit if
needed.
7.
Place one of the Light Mount Brackets into the Light Bucket as shown in
Figure 6
and loosely hand-tighten with two #10-32 Nuts. (The slots in the flanges will slide
over the threaded studs in the Light Bucket).
8.
Place a washer onto the adjustment post of the fog light, then slide the fog light
into the Light Bucket through the side at a slight angle as shown in
Figure 7
on the
next page.
Adjustment Post
BEFORE
Adjustment Post
AFTER
RETAINING TAB
Adjustment Post
Pivot Post
Figure 4
Figure 5
Figure 1
Figure 2
Figure 3
Figure 6
