©2012 Warn Industries, Inc.WARN® and the WARN logo are trademarks of Warn Industries Inc.
7
88783A3
I N S T A L L A T I O N I N S T R U C T I O N S
INSTALLATION (Pro-Pivot Assembly)
11. The plow blade can now be reinstalled on the push tube
assembly (reverse steps 1-2 and torque to specifications)
and the push tube assembly reconnected to the vehicle.
INSTALLATION cont. (Switch Mounting)
12. The Power-Pivot switch is mounted to the top of the winch
handlebar switch (mini rocker).
13. Remove winch handlebar switch from mount. See Figure
12. Note: It may not be necessary to remove mounting
bracket from handlebar.
14. Reassemble winch handlebar switch with supplied #6
screws as shown in Figure 13. Screws extend through
winch switch, fastening to threaded standoff of new Power-
Pivot switch.
15. Reattach winch handlebar switch to mounting bracket
removed in step 13.
Figure 12
Figure 13
Use a test light to locate a suitable wire.
W A R N I N G
TO PREVENT SERIOUS INJURY OR DEATH FROM ELECTRICAL FIRE:
• Do not route electrical cables across
sharp edges.
• Do not route electrical cables through
or near moving parts.
• Do not route electrical cables through
or near any high heat parts.
• Avoid pinch and wear/abrasion points
when installing all electrical cables.
TO AVOID INJURY AND PROPERTY DAMAGE:
• Use caution when moving or repositioning any vehicle controls
so as to not compromise the safe operation of the ATV. Select a
mounting position that will provide clearance for all vehicle controls.
• Before securing the switch cable with tie wraps, make sure that the
handlebars have full range of motion.
Figure 11
Remove
Discard and replace with new
hardware
Winch Switch
Power-Pivot Switch
New Hardware
