2018151_d•en•2019-10-01
We reserve the right to make technical changes
2
The central frame/plate can be ordered as an
optional accessory if necessary.
Fig. 2
Mounting structure for the WMS Wall-mounted transmit-
ter plus
WMS Wall-mounted transmitter plus (included in the
scope of delivery),
Central frame/plate (on-site or can be ordered as an
optional accessory),
Switch program frame (on-site or can be ordered as an
optional accessory),
Mounting frame (included in the scope of delivery).
Iperating elements and displays
①
③
④
⑥
⑤
⑦
②
Fig. 3
Operating panel of the WMS Wall-mounted transmitter
plus
Pos. Fig. Function WMS Wall-mounted transmitter plus
+
+
"Control function" on/off button
Briefly press the buttons
+
and
simultaneous-
ly (the control button
in other WMS Hand-held
transmitters). The comfort control functions are
switched on or off for all learned receivers in the
currently selected channel.
②
Comfort button
This button can be used to save and call up com-
fort positions.
③
AP/SUIP/DIWO buttons
Send move or switch commands to the selected
receiver.
If the WMS Wall-mounted transmitter plus is in the
info or learn mode, the buttons can be used to
change or save settings.
Pos. Fig. Function WMS Wall-mounted transmitter plus
④
Control function LCED
with two functions
When you press the buttons
+
and
simul-
taneously, the LED indicates whether the
comfort control functions are active or inactive.
If operation is blocked on your WMS Wall-
mounted transmitter plus, for example because
of a wind alarm, this LED flashes red. (The wind
alarm keeps your sun shading products safe.
When the set wind speed limit is exceeded, the
blinds are retracted and manual operation is
blocked during this time.)
Uransmission LCED
flashes.
GRCECEO:
The WMS Wall-mounted transmitter plus is trans-
mitting.
RCED:
The WMS Wall-mounted transmitter plus did not
receive a response from the receiver.
IRCOGCE:
Change the batteries.
④
+
+
Uhe control function LCED
and transmission
LCED
flash
IRCOGCE:
WMS Wall-mounted transmitter plus is in its factory
state (does not belong to a network, still needs to
be learned in).
IUTCCE
O
If the two buttons flash red, you
pressed the button for too long
and you are now in the factory
mode. To leave this mode, press
the learn button briefly.
1
2
3
4
5
6
LCED display channel 1 to 6
The selected channel lights up red
(e.g. here no. 2).
+
Channel change button
+
Using the
+
button switches between channels
1 to 6.
IUTCCE
O
Should there be channels that are
not assigned, the display skips
over them to the next assigned
channel (e.g. from channel 1 to
channel 3). If you have just as-
signed channel 2, press the
+
button for 5 s. A brief press of the
button then selects the desired
channel (channel LED flashes).
In this mode, you can then assign the
previously empty channel by pressing the L
button within 8 s and launching the learning/
copying process. The mode is closed auto-
matically after 8 s (channel LED no longer
flashes and is only lit).
IUTCCE
O
The exception is factory mode:
here, the WMS Wall-mounted
transmitter plus remains in
expanded selection mode, even
if the start channel is selected
again.
