890557_d•en•01.07.2014
We reserve the right to carry out improvements
87
7.5.2 isplay
In this menu you adjust the view of the display or change the behaviour of
the operating elements.
Press the [
Sett.
] function button in the main menu and then go to the
[
System
] > [
Display
] menu.
The following menu is displayed:
The display is normally set by the factory for easy readability. However, you
can adjust it here to your personal needs and to the light incidence at the
installation location.
7.5.2.1 Brightness at standby
If the Wisotronic is not operated for longer than 3 minutes, the display is set
to a freely adjustable brightness value (e.g. darkened).
Set this [
Brightness at standby
] in the first menu line:
Press the touch wheel; the value on the right becomes editable and the dis-
play is dimmed to the indicated value.
By turning the touch wheel to the right or left, the bar moves and the bright-
ness is increased or reduced.
You will see the effects by the change of the display. If you select a setting
below 10% (OFF is displayed), the display will go completely dark after 3
minutes. The brightness is increased by turning the touch wheel in a clock-
wise direction.
The [
Stand.
] function button sets the factory setting of 20%.
7.5.2.2 Brightness at operation
Set the [
Brightness at operation
] in the same manner in the next menu
line.
The brightness during operation can be reduced to a minimum level of 10%.
Darkening the display completely during operation is counterproductive.
The factory setting ([
Stand.
] function button) is 30%.
Start menu
Main menu
Settings
System
Display
System settings
