890557_d•en•01.07.2014
We reserve the right to carry out improvements
81
7.3.2.3 Hand-held transmitter
allocation
In this menu line you can assign radio transmitters to a scene. Proceed as
described in
Chapter 7.2.11 on page 76
for a channel.
You can call up the scene by pressing button
C
on the assigned transmitter.
7.3.2.4 elete scene
In this menu line you delete a scene you have created again.
With the touch wheel select the menu line [
Delete scene
].
The following warning appears on the right: [
Delete scene?
].
Press the touch wheel once more for deletion.
7.3.2.5 Holding time hh:mm
In this menu line you set the so-called "Holding time" where a called scene is
held for the holding time duration. During this holding time, no comfort func-
tions are carried out on the affected channels. However, manual operation
and safety functions can by-pass this scene.
The setting range is 00:00 to 24:00 hours.
NOTE
If switching time commands are received while the holding time runs down,
they are executed after the holding time has expired.
NOTE
The following applies to a disabled product: If the global automatic control
has been deselected in the main menu, the last move command is not re-
peated when the lock is cancelled (after a scene, leave or absence).
Turn the touch wheel to set the hours of the "Holding time hh:mm" value.
Pressing on the wheel causes the display to jump to minutes. Set the min-
utes in the same manner.
The function button [
Stand.
] sets the holding time to the factory setting.
7.3.2.6 Scene member 1
In this menu line, assign one channel to the current scene, allowing you to
call it up later with the scene.
Select the [
Scene member 1
] menu line with the touch wheel and press the
touch wheel.
Select the desired channel now by turning the touch wheel. The channel is
assigned to the scene by subsequently pressing the touch wheel.
The function button [
Delete
] removes the channel assignment.
NOTE
Because Wisotronic 1-channel has only one channel, only channel 1 or ---
can be selected here.
7.3.2.7 Scene member 2 to 4
These functions are not enabled since Wisotronic 1-channel has only one
channel.
Channels, groups, scenes
