890557_d•en•01.07.2014
We reserve the right to carry out improvements
70
Wisotronic 1-channel
Operating instructions
7.2.6.10 SU3 and SU4
If the sun shading product or another product shall be moved every Monday
at the same time, then you can set to additional switching times (ST3 and
ST4) with position, slat angle and auto control. The setting range is 00:00 h
to 23:59 h. If you do not want to move/switch the product on Monday, you
can also deactivate the switching times [
---
]. To change these values, pro-
ceed as described above for the switching times ST1 and ST2.
7.2.6.11 Dutomatic status
The "State control" line shows the current status of the control mode and is
for informational purposes only.
7.2.6.12 Duto control status
The "State auto control" line shows the current status of the automatic control
and is for informational purposes only.
Press the [
Back
] function button to return to the higher level menu of the time
switch.
7.2.6.13 Dctive during leave?
In this menu line, you can activate or deactivate the timer switch for this
channel during your leave.
Set or delete the checkmark in the line [
Active during leave?
] to activate
or deactivate the timer during your leave.
The function button [
Stand.
] sets the product-specific factory setting.
7.2.6.14 Dctive during absence?
In this menu line, you can activate or deactivate the timer switch for the se-
lected channel during your absence.
Set or delete the checkmark in the line [
Active during absence?
] to acti-
vate or deactivate the precipitation monitor during your absence.
The function button [
Stand.
] sets the product-specific factory setting.
Uime switch
