warema_890558_alhb_en_v5•2022-02-01
We reserve the right to carry out improvements
77
8.9 Ending service access
In this menu line you can close the password-protected service access so
that only the settings for the operator are accessible.
If you return to the main menu after commissioning has been completed, a
small stylised wrench appears in the header at the upper right:
This wrench will be visible for one hour because you logged in as a spe-
cialist dealer earlier. During this time, the service menus can be accessed
without a password to perform additional settings. This mode can be closed
immediately by disconnecting and reconnecting again or using the [
Sett.
] >
[
Service
] > [
End service access
] menu item.
After an interruption in the power supply, the service mode is no longer ac-
tive. However, changes made to the parameterisation are retained.
To make it possible to call up these changes at any time using the
[
Restore settings
] function, you should enter the service mode again and
save them using [
Adopt settings
] or when leaving the service mode.
Main menu
Settings
Service
End service access
Service access
