warema_890558_alhb_en_v5•2022-02-01
We reserve the right to carry out improvements
75
8.7 Loading data into the
actuator
Here you have the option of loading data into the actuator. This step is need-
ed to make the settings available for normal operation of the Wisotronic.
[
Please wait...
] appears followed by [
Write to Actuator
].
The display disappears again after this process is finished.
Pressing the [
Canc.
] button takes you back to the [
Project setup
] menu.
After
Devices are newly created (actuators, sensors)
Devices are replaced
Devices are deleted from the project
all devices need to be loaded for the changes to take effect.
Be sure to subsequently raise all channels manually (reference run) to en-
able the control to flawlessly move to the absolute positions.
CAUTION
Do not carry out any operations on site while uploading to the devices.
Locks and all safety functions are not active during this period.
Main menu
Settings
Service
Project setup
Load data into the actuator
Load data
