warema_890558_alhb_en_v5•2022-02-01
We reserve the right to carry out improvements
71
8.4.10 Duration of the automatic
calibration
The automatic calibration causes the drive motor (if present) to run slightly
longer when moving a products to its upper or lower limit position to com-
pensate for slip. This ensures that the actual position of sun shading prod-
ucts still matches the target value (0-100%) even after many movements.
8.4.11 Manual mode
Different operating modes are available for local manual operation:
Different sun shading products require different control options. For example,
it is useful to be able to adjust the slat angle of external venetian blinds by a
brief move command while this makes little sense for awnings or roller shut-
ters. Depending on the sun shading product to be controlled, the following
control options can be selected:
No manual operation
This setting completely excludes manual operation on the local pushbuttons
and on the control panel.
Dead man
With this setting, the sun shading product moves in the desired direction until
the button is released again.
Permanent mode
This control option is useful for roller shutters and fabric products. The prod-
uct is raised immediately after the "Up" button is pushed. The drive stops
when the "Down" button is pushed during raising.
The product is lowered immediately after the"Down" button is pushed. The
drive stops when the "Up" button is pushed during lowering.
The product can also be stopped at any time using the stop button in the
centre.
Radio time mode
This mode is useful for slat products: By briefly activating (< 0.6 seconds)
the "Up" or "Down" button you can adjust the sun shading product in small
steps. This function can be used with slat products to tilt the slats. If the but-
ton continues to be activated beyond this, the radio time mode switches to
the lock mode. The button may then be released. The sun shading product
moves until the run time has elapsed. To release the lock and stop the motor,
the button for the opposite direction of movement or the stop button must be
pressed.
Products
