12
07610-004-37-37-P
INSTRUCTIONS
INSTALLATION
8. Press ENTER button. This saves the changed parameters and exits the
programming mode. PGM light will go from steady to flashing.
9. To change any other values, repeat the process above. To revert back to a
previous setting, repeat the process above and change parameters back to
previous settings.
In programming mode, if there have been no keypad inputs for approximately two
minutes, the system will automatically exit out of programming mode. Any changes
to parameters will be lost when programming mode is automatically exited.
The dishmachine is designed to operate while level. This is important to prevent any
damage to the machine during operation and to ensure the best possible results.
The unit comes equipped with adjustable bullet feet which can be turned using a
pair of pliers. Since this machine is an undercounter unit, it should be leveled as
close as possible to the unit's location before it is pushed under the counter.
1.
Press POWER button and listen for machine to stop filling.
2. Press POWER button and listen for machine to stop draining.
3. Repeat Steps 1 and 2.
4.
Press POWER button and listen for machine to stop filling.
5. Machine is now ready for operation.
1 2 3 4 5 6 7 8
ON
8
4
2
1
0.8
0.4
0.2
0.1
A
B
C
D
E
F
G
H
PGM
ACCEPT
MOVE
ENTER
IN
SEC
LIGHTS
TIME
BUTTONS
CHECK FUSE
PROGRAMMING
CHEMICAL FEEDER
PUMPS (UL30)
LEVELING
x2
180
180
180
INITIAL FILL
(UH30-FND ONLY)
UH30-FND models with
serial numbers before
23D415452 have different
initial fill instructions.
Click here to open earlier
manual.