07610-004-37-37-P
9
3. The amount of detergent might need adjustment depending on water quality and
type of detergent. The amount of rinse-aid might need adjustment depending
on water hardness and results. Refer to UH30-FND Setpoints section for
instructions on adjusting amount of chemicals being dispensed.
UL30
4. Hold each prime switch (Detergent, Rinse-aid, and Sanitizer) until the respective
chemical can be seen entering the wash tank.
5. Detergent is dispensed as required during the wash cycle by the timer. The
amount of detergent might need to be increased or decreased depending upon
water quality and type of detergent.
6.
Rinse-aid is dispensed as required into the final rinse. The amount of rinse-aid
might need to be adjusted depending upon water hardness and results.
7.
Sanitizer is dispensed proportionally into the final rinse water line. The amount
of sanitizer might need to be adjusted depending on concentration.
8. See Programming Chemical Feeder Pumps (UL30) section to adjust chemical
amounts using the universal timer.
INSTRUCTIONS
INSTALLATION
PRIMING CHEMICAL
FEEDER PUMPS
PROGRAMMING
CHEMICAL FEEDER
PUMPS (UL30)
To access programming mode, machine must be ON and between cycles.
The PROGRAM (PGM) light will be flashing.
1. Locate universal timer. On the timer, locate programming board and
programming buttons.
8 7 6 5 4 3 2 1
ON
CHECK FUSE
Universal timer is
located on control panel.
Use Parts section of this
manual for reference.
UL30 DIP-switch Settings
(0 = On, X = Off)
←
ON
X X X X
0 0 0 0
8 7 6 5 4 3 2 1