W&T Microwall Gigabit 55210, Manual

Page: 18 / 75

18
W&T
Hardware, interfaces and displays
2�4 System- and Error LED
System LED
Service LED
2�4�1 System LED (green)
ON : Signals normal operational readiness.
Flashing : The Microwall performs a reboot or receives a new
firmware.
2�4�2 Service LED (red)
The service LED is used to signal the emergency access and
factory default reset functions that can be controlled via the
service button.
Slow flashing: The service button was pressed between 3.5s
and 10s. The emergency access of the Microwall is activated.
Further information on emergency access can be found in the
chapter on
emergency access.
i The emergency access opens a non-password-protected
HTTPS access (TCP port 446) with the possibility to over-
write the current password. Therefore, only start the emer-
gency access in an appropriately secure environment (e.g.
direct connection to a configuration PC).
Fast flashing: The service button was pressed for longer
than 10s and the Microwall is preparing a reset to the factory
settings. If the service button is still pressed, a reset to the
factory settings is performed after a total of 20s.